Polished Titanium Rod for Industrial Fasteners

Fasteners need consistent diameter. Smooth surface. No defects. You can't make good bolts, screws, or studs from rough rod.

Polished titanium rod for industrial fasteners starts with high-quality titanium bar. Then we polish it. Smooth surface means less wear on your forming dies and thread rolling equipment. Consistent diameter means every fastener comes out the same.

Bolt manufacturers, screw machine shops, and aerospace fastener suppliers use this rod every day.

Most titanium rod comes turned or ground. That's fine for general machining. But fastener manufacturing is different.

You're feeding rod into automatic screw machines or cold heading equipment. Rough surface causes feed issues. Scratches on the rod become scratches on the finished fastener. Variable diameter causes rejects.

Polished titanium rod for industrial fasteners gives you:

Smooth surface (Ra ≤ 0.4μm). No scratches or surface defects. Tight diameter tolerance (±0.025mm or better). Consistent roundness. Ready for thread rolling and head forming.

Grade 5 (Ti-6Al-4V)

Grade 2 (pure titanium)

Most industrial fasteners use Grade 5. Higher strength. Better for structural bolts, high-stress applications, aerospace fasteners.

Grade 2 is softer. Lower strength. Used for non-critical fasteners, medical applications, or where corrosion resistance is the only requirement.

For polished titanium rod for industrial fasteners, Grade 5 is the standard. Grade 2 is the exception.

Take a roll of polished titanium rod for industrial fasteners. Run it through a screw machine or cold header. You get:

• Bolts and screws for marine hardware. Won't rust in salt water.
• Aerospace fasteners. Light weight. High strength. AMS certified.
• Chemical plant studs and nuts. Resists acid and chloride corrosion.
• Medical bone screws. Biocompatible. Grade 2 or Grade 23.
• Bicycle and motorcycle hardware. Light and strong.

Every one of these fasteners starts with good rod. Polished surface. Tight tolerance. No defects.

Titanium cold heads differently than steel. It's less ductile. Work-hardens faster.

For polished titanium rod for industrial fasteners, the polish helps. Smooth surface reduces friction in the heading die. Fewer rejects. Longer tool life.

Thread rolling works well on titanium. The rolling process compresses the surface, which improves fatigue life - important for threaded fasteners.

Use sharp rolling dies. Clean the rod before rolling (our polished rod is clean and ready). Lubricate properly.

We've had fastener makers tell us our polished rod runs 20–30% longer between die changes compared to ground rod. Less downtime. More parts per shift.

Fastener manufacturers hate variable rod diameter. It jams feeders. It changes head volume. It causes thread height variation.

Our polished titanium rod for industrial fasteners holds diameter to ±0.025mm. That's h6 tolerance.

Roundness is within 50% of diameter tolerance. Out-of-round rod makes hex heads look wrong.

Every lot gets diameter checked at three points along the length. We keep the data.

Ra ≤ 0.4μm. That's about as smooth as ground rod gets. But polished has fewer directional lines.

No residual lubricant or cutting oil from the polishing process. Our rods are cleaned after polishing. You can run them straight into your cold header or screw machine without degreasing.

No burrs at cut ends (if you order cut lengths). We chamfer and deburr every cut.

You don't buy polished titanium rod for industrial fasteners because it's fancy. You buy it because rough rod makes bad fasteners.

Consistent diameter. Smooth surface. Clean and ready to run. That's what fastener manufacturing requires.

Grade 5 for strength. Grade 2 for corrosion-only applications. Polished finish for reliable feeding and long tool life.